sales@hncmec.com

  >  Home > 技术答疑

技术答疑

Optical Ground Wire For Communication Between Power Substati

By Aleen Mohammed / Last Updated on 

With the advent of modern microprocessor relaying, much of the communication between relays has been shifting from power-line-carrier apparatus or microwave to fiber.

Since power utilities own the easements for the high voltage transmission lines, it is only logical to install fiber up there. One ingenious location is the lightning shield wire. It is the top most wire on the tower. It is not a current carrying wire, so no line sag issues (due to heat). Also the wire is smaller gauge, so there’s less impact to the tower design.

OPGW Location

The shield wire constructed with fiber inside it is called the Optical Ground Wire (OPGW). The one shown in the GIF image comes with up to 144 count fiber. Additional specifications on its construction can be found here.


From relaying standpoint only 2 fibers are needed (1-TX, 1-RX) for each relay pair. Typical connection looks like below.

Fiber Hookup Between Substation Relays

The fiber coming in from outside and the one coming in from the relay gets spliced inside a fiber distribution panel. See video below on how fiber gets spliced.

Fiber Specification

Distances between substations could be a few miles to sometimes hundreds of miles. The laser light traveling inside the fiber needs to traverse these distances. To minimize light reflections, which impacts how far the light travels, the core is constructed with a diameter as small as possible. A 9micron core fiber (a.k.a. single mode) is used for communication between substations. A 62.5micron fiber (a.k.a. multimode) is used for communication within the substation. Note the core to cladding ratio for this fiber in the image below.


Core to Cladding ratio for a single mode and multimode. Image courtesy: Fibersystems

Another item to consider is the wavelength of the light. Light inside a 9micron fiber at 1300nm wavelength can travel 80km. Whereas, in the same 9micron fiber, a 1550nm wavelength light can travel 120km.

An excellent value proposition for power utilities is to lease few fibers to telecom or internet service providers. Considering how much high voltage transmission lines cover the length and breadth of USA (see below image), imagine if most wires had fiber. Gigabit internet service for most folks will be within reach.
Please free to contact us if you are interested in optical fiber cable and lugs,www.hncmec.com

Contact Us

Skype: richtang731

Phone: 18900751339

Tel: 0731-85499326

Email: sales@hncmec.com

Add: 中国•湖南•长沙市韶山南路123号

Scan the qr codeClose
the qr code